Useful Parts
Good link for searching electronics: https://octopart.com/ (distributor independent)
- HFW8R-1STE1LF
-
SFW8R-2STE1LF
Fits the solder pad layout on the teensy 4 but the lock tabs are a little too wide to fit between the header pins if used. The tabs are only plastic though and can be trimmed with a sharp knife/scalpel (see post)
It is expected that a Teensy 4.1 will be released that uses a Teensy 3.5/3.6 form factor and will include a micro-SD card reader.
Alternatives for bringing out the SD card pins on the Teensy 4.0.
Make your own cables of custom sizes and lengths:
- Crimp connector housings
- Wires with pre-crimped terminals
- Female crimp pin headers
- Male crimp pin headers
- Crimping tool #1
- Crimping tool #2
- Video explaining about the wires and crimped connectors
Here are some of the prototype boards for mounting your project via soldering:
- DrAzzy: Various sizes of prototype boards
- DrAzzy: 2" x 4" prototyping boards
- DrAzzy: 1" x 2" prototyping boards (perfect for Teensy 3.2/4.0)
- DrAzzy: mint-tin prototyping board
- DrAzzy: Prototype boards with breakaway mounting holes
- DrAzzy: 4" x 4" premium prototyping board
- Adafruit mint-tin perma-proto board
- Adafruit plain mint-tin container
- Adafruit 1/2 sized perma-proto board
- Adafruit 1/4 sized perma-proto board
- Adafruit full sized perma-proto board
- Adafruit small mint-tin perma-proto board (just right for Teensy 3.2/4.0)
- Adafruit combination perma-proto pack
- ElectroCookie combination prototype boards
- ElectroCookie double column prototype board
- ElectroCookie large prototype board