From b08550d68f00291ea2a366170988a1a9bb11ff7f Mon Sep 17 00:00:00 2001 From: Yurttas Date: Tue, 23 Sep 2025 10:39:22 +0300 Subject: [PATCH] fixed wrong jumper settings for power monitoring --- .../MAX7800x Power Monitor and Energy Benchmarking Guide.md | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Guides/MAX7800x Power Monitor and Energy Benchmarking Guide.md b/Guides/MAX7800x Power Monitor and Energy Benchmarking Guide.md index b771833..2130813 100644 --- a/Guides/MAX7800x Power Monitor and Energy Benchmarking Guide.md +++ b/Guides/MAX7800x Power Monitor and Energy Benchmarking Guide.md @@ -65,7 +65,7 @@ To load a PMON firmware image, connect the dedicated PMON USB port (J1 on MAX780 JP3 and JP4 must be installed for windowed power accumulation mode to work. -All “bypass” shunts must be removed: JP2, JP4, JP5, and JP6. +All “bypass” shunts must be removed: JP17, JP13, JP16, and JP15. JP10 and JP8 must be set to the “INT” position. JP9 may be set to either position depending if the currents for GPIO pins on VDDIO are desired to be included in the 1V8 measurements. Set to “INT” to include these currents. Usually, these currents are not desired to be included since they are board specific. In this case set, JP9 to “EXT”. @@ -75,7 +75,7 @@ Select the desired position for JP11 and JP12 to source VCOREA and VCOREB from t JP18 and JP19 must be installed for windowed power accumulation mode to work. -All “bypass” shunts must be removed: JP17, JP13, JP16, and JP15. +All “bypass” shunts must be removed: JP2, JP4, JP5, and JP6. JP1, JP3, JP7, JP8, JP11 - JP14 must be installed. JP9 must be set to the 3V3PM position.