Support for Omnio Switches (EEP D2-01-11)

[hunzikerc]

Hi
First of all, thanks for your work, which I highly appreciate.

I'm using an Omnio switch actor UPS230/12 (2 channels) which uses EEP D2-01-11. So far I wasn't able to pair the device with my USB300. EEP D2-01-12 is probably similar and I managed to read status of the switch with it, however could not actively switch. I wonder wheter it is possible to add support for this device class?

Many thanks
Christoph

[ChristopheHD]

Hi,
The only difference between D2-01-11 and D2-01-12 is the possibility to changes the settings in D2-01-12 (which is not possible D2-01-11). Using EEP configuration D2-01-12, you should be able to pair and switch.
Can you share your configuration to check why you can't pair and switch ?

[hunzikerc]

Hi ChristopheHD
Thank you for your fast reply. My device configuration is as follows:

[lichtschalter_bad]
address = 0x0029017A
rorg = 0xF6
func = 0x02
type = 0x01

[switch_bad]
address = 0x01919CD1
rorg = 0xD2
func = 0x01
type = 0x12

[virt_ls_bad1]
address         = 0xFFFFFFFF
rorg            = 0xF6
func            = 0x02
type            = 0x02
sender          = 0xFFB74688
virtual         = 1

I get this on my Overview:

If I move the switches on the dashboard they jump back to the current switching state which is reflected correctly.

As well as virtual switches:

I assumed the virtual push buttons generate the same signal as my real ones, but no effect.

Any hints are very welcome.

Best regards
Christoph

[ChristopheHD]

For information: this repository is not maintained anymore, I would recommend you to switch to my fork https://github.com/ChristopheHD/HA_enoceanmqtt-addon
Following your will to use the EEP D2-01-11, I just added this EEP in my latest release so you can have the correct EEP set in your configuration.

[hunzikerc]

Thanks for integrating EEP D2-01-11 in your newest release. I upgraded to 0.1.41 and changed the configuration of my switch "e2m_switch_bad" to EEP D2-01-11. However, if I do so, the switching state is not updated anymore if I change switching state with my physical push buttons. This only works if I go back to the "wrong" EEP D2-01-12 which is not officially supported by my Omnio switch.

I still have the problem not being able to switch from homeassistant. I'm not sure if pairing is not working. I tried it several times with seemingly no success.

Any hints very welcome.

Best regards
Christoph

[ChristopheHD]

to EEP D2-01-11. However, if I do so, the switching state is not updated anymore

That's weird, because D2-01-11 and D2-01-12 have the exact same configuration for the addon.

I still have the problem not being able to switch from homeassistant.

Looks like a pairing problem. Have your device got a LED that can indicate if the pairing procedure have succeded or not ? You can also generate debug log of the addon when doing the pairing procedure, maybe this can help to understand the issue.